At-gs950 8 Poe User Manual

 

With user-friendly web-based management, the GS950 Series is an ideal option for integrating simple management and security into a network solution. Power over Ethernet Plus (PoE+) The GS950 PS Series is available in PoE configurations of 10-, 16- and 48-port. At-gs950/10Ps 75W 8 4 2 At-gs950/16Ps 185W 16 12 6 At-gs950/48Ps 370W 24 24 12. AT-GS950/16PS - read user manual online or download in PDF format. Pages in total: 386. AT-GS950/16PS - read user manual online or download in PDF format. Pages in total: 386. Page 283Chapter 22 Power Over Ethernet (PoE).

Download 386 pages, 12 Mb
Success! {{ $ctrl.successMessage }}
0'>Errors!
>
340
Gs950Configure Factory DefaultValues

At Gs950 24

The following procedure returns all AT-S110 Management software
parameters to their factory default values and deletes all tagged and port-
The AT-S110 Management software factory default values are listed
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
1.From the main menu on the left side of the page, select the Tools
The Tools folder expands.
The Reboot Page is displayed. See Figure 133 on page 338.
3.Go to the lower part of the page to the Reboot section.
4.In the Reboot Type field, use the pull-down menu to select one of the
Normal - This setting reloads all configuration parameters that are
saved in flash memory. See “Switch Reboot” on page 338 for more
Factory Default - Resets all switch parameters to the factory
Manual
default settings, including the IP address, subnet mask, and
This setting will cause the IP address to be reset to 192.168.1.1.
You will loose connectivity with the switch management software

At Gs950 48ps 10

after the reboot is completed and you can login again with this IP

At Gs950 10ps 50

Factory Default Except IP Address - Resets all switch parameters to

At Gs950 10ps

the factory default settings, but retains the current IP address, subnet
mask, and gateway settings saved in flash memory. If the DHCP client

At Gs950 16 10

is enabled, it remains enabled after this reset and assignment of the IP